NSNorth Shore HVAC
Riverwoods · Lake County, Lake County

Furnace Replacement in Riverwoods, Illinois

Furnace Replacement in Riverwoods typically costs $4,500-$9,000 installed in 2026, depending on home size and efficiency tier.

Riverwoods was platted to keep the woods intact, and a lot of what got built here in the 1950s and 60s was heated by radiant or hydronic systems rather than a furnace. Where a Riverwoods house does run forced air, it is usually a later addition or a full conversion, and the ductwork it inherited decides more about the replacement than the furnace nameplate does.

Typical Riverwoods price range
$4,500-$9,000 installed
Smaller homes (under 1,500 sq ft)$3,800-$7,900
Typical homes (1,500-2,500 sq ft)$4,500-$9,000
Larger homes (2,500-4,000+ sq ft)$5,000-$11,900

Final pricing depends on system size, efficiency, and home configuration. Every quote is written and itemized after a free in-home estimate, with available utility rebates factored in. See current North Shore rebates or get an instant ballpark estimate.

Furnace Replacement for Riverwoods homes

The forced-air homes in Riverwoods tend to be the ones that were converted off radiant or built later on the Deerfield side, and the duct runs threaded into a low-slung mid-century are almost always tight on return air. That shows up as a furnace that runs long, a plenum that whistles, and rooms at the far end of the house that never catch up. We measure the home and the distribution before we pick equipment, because dropping a larger furnace onto an undersized return just moves the noise around and shortens the blower's life.

A condensing furnace in the 90-98% AFUE range is the right target here, but the install has to respect houses with shallow roofs, finished lower levels and no basement in some cases - PVC venting and condensate routing need a plan before anyone starts cutting. Licensed, insured installers handle the venting, verify combustion, haul the old unit out, register the warranty, and we walk you through the Nicor rebate the new equipment qualifies for. Where the ducts genuinely cannot serve a wing of the house, we will say so and price a ductless zone instead of pretending the furnace can fix it.

When Riverwoods homeowners call us for this

  • System is 15+ years old or out of warranty
  • A repair would cost a large share of a new unit
  • Rising energy bills or uneven comfort
  • Repeated breakdowns in a single season
  • Phased-out refrigerant (older R-22 AC)
  • Planning ahead before a full failure

Why Riverwoods homes need replacement planning

Riverwoods was platted to keep the woods intact - no sidewalks, no streetlights, houses set well back on heavily treed acre lots along the Des Plaines River. Much of the housing stock is 1950s and 60s custom and mid-century modern, and a good share of it was built with radiant or hydronic heat and no ductwork at all. That makes cooling the hard problem here: adding conventional ducts to a low-slung mid-century with a flat or shallow roof usually means losing ceiling height, so ductless mini-splits and high-velocity systems do most of the work. The tree cover that makes the village what it is also buries condenser coils in leaf litter and seed, which is worth checking before anyone condemns a unit for running warm.

Talk it through - (847) 752-4418

Neighborhoods we cover in Riverwoods

ThornmeadowDeerfield borderDes Plaines River corridorWoodland Park

Our process

  1. 1
    Free in-home estimate

    A comfort specialist comes to your Riverwoods home, measures the space, checks ductwork and venting, and explains options and honest price ranges in writing - no charge, no pressure.

  2. 2
    Right-sized equipment

    We size the system with a proper load calculation and choose efficiency levels that qualify for the utility rebates you're eligible for.

  3. 3
    Professional installation

    Licensed, insured installers remove the old system and install the new one to spec.

  4. 4
    Rebates, registration & follow-up

    We register the warranty, hand off the utility rebate paperwork, and confirm everything is running right.

Frequently asked - Furnace Replacement in Riverwoods

How much does furnace replacement cost in Riverwoods?

Furnace Replacement in Riverwoods typically runs $4,500-$9,000 installed, depending on system size, efficiency, and how the home is configured. We provide a written, itemized estimate from a free in-home visit for every Riverwoods project - and factor in the utility rebates you qualify for.

Do you serve all of Riverwoods?

Yes. We cover every neighborhood in Riverwoods, including Thornmeadow, Deerfield border, Des Plaines River corridor, Woodland Park and surrounding areas.

Are you available 24/7 for emergencies in Riverwoods?

Yes. We run a 24/7 line across Riverwoods for no-heat and no-cool emergencies and can prioritize dispatch.

What kinds of systems do you commonly replace in Riverwoods?

In Riverwoods we regularly work with Mid-century radiant and hydronic heat, Ductless mini-splits, High-velocity retrofit AC, Zoned forced-air systems, Heat pumps. We match the approach to the home's age, ductwork, and venting.

Furnace Replacement guides

Looking for the full picture on Furnace Replacement or everything we do in Riverwoods? Explore those pages, or call (847) 752-4418 for a free estimate today.

Call NowFree Estimate